Acer 2930 manual Main, Parameter Description Format/Option

Main

The Main screen allows the user to set the system time and date as well as enable and disable boot option and recovery.

		InsydeH20 Setup Utility		Rev. 3.5
Information	Main	Advanced	Security Power Boot	Exit
System Time			[13:04:04]	Item Specific Help
				This is the help for the
System Date			[06/04/2008]	hour field. Valid range
				is from 0 to 23.
Total Memory			4095 MB	INCREASE/REDUCE : F5/F6
Video Memory			[32MB]
Quick Boot			[Enabled]
Network Boot			[Enabled]
F12 Boot Menu			[Disabled]
D2D Recovery			[Enabled]
SATA Mode			[AHCI]
F1 Help	↑↓ Select Item		F5/F6 Change Values	F9 Setup Default
ESC Exit	←→ Select Menu		Enter SelectXSubMenu	F10 Save and Exit

NOTE: The screen above is for your reference only. Actual values may differ.

The table below describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings.

Parameter	Description	Format/Option
System Time	Sets the system time. The hours are displayed with 24-	Format: HH:MM:SS
	hour format.	(hour:minute:second)
System Date	Sets the system date.	Format MM/DD/YYYY
		(month/day/year)
Total Memory	This field reports the memory size of the system.	N/A
	Memory size is fixed to 3017 MB.
Video Memory	Shows the video memory size. VGA Memory size=32 MB	N/A
Quick Boot	Allows startup to skip certain tests while booting,	Option: Enabled or
	decreasing the time needed to boot the system.	Disabled
Network Boot	Enables, disables the system boot from LAN (remote	Option: Enabled or
	server).	Disabled
F12 Boot Menu	Enables, disables Boot Menu during POST.	Option: Disabled or
		Enabled
D2D Recovery	Enables, disables D2D Recovery function. The function	Option: Enabled or
	allows the user to create a hidden partition on hard disc	Disabled
	drive to store operation system and restore the system
	to factory defaults.
SATA Mode	Control the mode in which the SATA controller should	Option: AHCI Mode or IDE
	operate.	Mode

NOTE: The sub-items under each device will not be shown if the device control is set to disable or auto. This is because the user is not allowed to control the settings in these cases.

Chapter 2 25