PHASE RESEARCH
USER GUIDE
9.Press 
or 
to select the desired daypart.
10.Press 
to move the cursor to BEEP.
11.Press 
to move the cursor to [=] immediately to the right of BEEP ON ARRIVAL.
12.Press 
or 
to toggle the BEEP ON ARRIVAL option to YES or NO.
13.Press 
to select the grade (A, B, C, etc.) for which you wish to set or change the target time. (If you do not want targeting for a particular grade, set the grade’s target time to 0.)
NOTE: The target time for B must be equal to or greater than that for A; the target time for C must be equal to or greater than that for B, and the same applies through the entire sequence of letter grades. The Timer adjusts automatically to ensure this.
Pass/Fail grading may be used rather than letter grading: Set all letter grades except F to the same time – the maximum time allotted to the event (MENU, GREET, etc.) to achieve a passing grade. For example, if you want to make 10 seconds the (Pass) time, set A, B, C, and D to a time of 10 (the selected event must occur within this amount of time in order to “pass.”).
14.Press 
to move the cursor immediately to the left of the B (beep) column field.
15.Press 
or 
to set the beep count for the grade you have chosen (0 - 9 beeps may be chosen). The Remote will beep (the number of times spec- ified) when the selected event exceeds the target time you have selected.
16.Press 
to move the cursor immediately to the left of the P (print) column field.
17.Press 
or 
to toggle the printing option for the grade to Y (yes) or N (no). If you select Y (yes), the Timer will print every car that falls within the particular grade’s target time.
SECTION 13 - PARAMETERS PROGRAMMING |