PHASE RESEARCH

USER GUIDE

13-1.9 Set Remote AddressingIF IT IS NECESSARY TO CHANGE A REMOTE DISPLAY’S ADDRESS,USE THE FOLLOWING STEPS:

1.Unplug the five-pin connector from the top of the Remote Display and remove the display from its mounting. Remove the two (2) smaller Phillips head screws from the top of the Display first, and then remove the two (2) Phillips head screws from the bottom of the Display. The two (2) covers of the Display should now separate.

2.After separating the two covers, locate the eight (8) position dip-switch block located on the upper right-hand side of the circuit board. Adjust the switches according to the addresses you want.

Remote Display Address Dip-Switch Settings

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OFF

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ON

8

 

7

 

6

 

5

4

 

3

 

2

1

 

 

 

 

 

 

 

 

 

 

 

Address 001: Switch 1 ON, 2 OFF, 3 OFF

Address 002: Switch 2 ON, 1 OFF, 3 OFF

Address 003: Switches 1 & 2 ON, 3 OFF

Address 004: Switch 3 ON, 1 OFF, 2 OFF

Address 005: Switches 1 & 3 ON, 2 OFF

Address 006: Switches 2 & 3 ON, 1 OFF

3.Plug the connector back into the Remote Display and verify that it has the cor- rect address before reassembling.

4.Once the Remote Display is addressed correctly, reassemble and remount it.

SECTION 13 - PARAMETERS PROGRAMMING

13-23