PHASE RESEARCH
USER GUIDE
NOTE: If you do not know the number associated with a particular Remote Display, remove and reconnect the
IMPORTANT! While Remote Displays that show the time of the same event can have either the same or different addresses, if you want two or more Remote Displays to show the time of different events, each display must be set to a different address. The address of the Remote is the third digit only of the first number that comes up after you power on the Remotes, e.g., for example, the address for 275 would be 5; the address for 005 would also be 5. (If the Display’s address is 001, it will show the time that Remote #1 is programmed to show as indicated on the Remote Display screen. If a Remote’s address is 002, it will show the time that Remote #2 is programmed to show, etc.)
4.Press 
to move the cursor immediately to the right of the individual Remote address number(s) (i.e., #1).
5.Press 
or 
to select the event that the Remote(s) will be monitor- ing. Adjust all other Remotes as needed.
NOTE: The optional sixth Remote Display setting serves as a special Percentage Remote which can be used to monitor speed of service, as well as to provide performance incentive for crew members. The Percentage Remote shows, in either red or green numerals, the percentage of cars that satisfy a particular grade’s target time. If the percentage of cars satisfying the particular grade’s target time is below a percentage selected by the user, the Display numerals will be red. If the percentage is equal to or higher than the selected percentage, the numerals will be green. Only the Percentage Remote and
NOTE: Steps 5.a. to 5.e. explain how to set up a percentage Remote or a
5.a. Press 
to move cursor to the sixth (last) Remote position.
SECTION 13 - PARAMETERS PROGRAMMING |