AEG TKS-CS operating instructions Maintenance and Inspection Visual Inspection, Cleaning

Compact Station TKS-CS - Operating Instructions

A correct test report, completed in full, is important for technicians as evidence of exoneration in case of later complaints or for investigations in case of damage. For this reason, test reports should be retained for a long time (around 10 years).

10.2Maintenance and Inspection

10.2.1Visual Inspection

Visual inspections should be carried out in accordance with DIN EN 13018.

Inspections must involve careful checks for the following in the equipment:

•Mechanical damage

•Corrosion, thermal changes to and tightness of the electrical connections

•Moisture

•Accumulation of conductive dirt or dust

•Defective fuses

•Foreign bodies

•Fans dirty or damaged (M2 and M3 when the waste air duct is open)

•Filter mat dirty or damaged

Safety devices and warning notices should be checked for damage and legibility.

If there is condensation in the equipment, the internal heating device should be checked to determine whether it is working properly.

10.2.2Cleaning

i	Only equipment tested in accordance with DIN VDE 0680 may
	be used for cleaning.
i	If there is condensation in the equipment parts that are to be
	cleaned, cleaning must not be carried out.

The cleaning procedure used must comply with the relevant regulations and provisions of the accident prevention regulation VBG 4 "Elektrische Anlagen und Betriebsmittel" (Electrical installations and equipment) and DIN VDE 0105-100 (Operation of electrical installations). Only specially trained electricians may carry out cleaning work when the equipment is live.

Page 28 of 39 8000043213 BAL