Notice to American UsersNotice to Canadian UsersNotice to German Users
Federal Communications CommissionRadio Frequency Interference Statement

Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio / TV technician for help.

FCC warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Notes

•Testing of this equipment was performed on model number M3878SA14AV.

•The use of a non-shielded interface cable with the referenced device is prohibited. The length of the parallel interface cable must be 3Ê meters (10Ê feet) or less. The length of the serial interface cable must be 15Ê meters (50Ê feet) or less.

•The length of the power cord must be 3 meters (10 feet) or less.

Laser Safety Information

This printer has been designed and manufactured according to FDA regulations “title 21, CFR, chapter I, subchapter J, based on the Radiation Control for Health and Safety Act of 1968”, and is classified as class 1 laser product.

Warning: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

This class B digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

Cet appareil numérique de la Classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

Bescheinigung des Herstellers/Importeurs

Hiermit wird bescheinigt, daß der M3878SA14AV der Maschinenlärminfor- mationsverordnung 3. GSGV, 18.01.1991 entspricht. Der höchste Schalldruckpegel

beträgt 70 dB (A) oder weniger gemäß EN27779-1991.

User’s Manual

FM-1