Notice to American Users

Notice to Canadian Users

Notice to German Users

Notice to European and Oceanian Users

In case that the interface board, Ethernet C, is installed, this equipment complies with EMI regulations as follows:

Federal Communications Commission

Radio Frequency Interference Statement

Notice: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

FCC warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Notes

•Testing of this equipment was performed on model number M3878SA14AV.

•The use of a non-shielded interface cable with the referenced device is prohibited. The length of the parallel interface cable must be 3Ê meters (10Ê feet) or less. The length of the Ethernet interface cable must be 100Ê meters (328Ê feet) or less for type 10BASE-2 and 185 meters (607 feet) or less for type 10BASE-T.

•The length of the power cord must be 3 meters (10 feet) or less.

Laser Safety Information

This printer has been designed and manufactured according to FDA regulations “title 21, CFR, chapter I, subchapter J, based on the Radiation Control for Health and Safety Act of 1968”, and is classified as class 1 laser product.

Warning: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

This class A digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

Cet appareil numérique de la Classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

Bescheinigung des Herstellers/Importeurs

Hiermit wird bescheinigt, daß der M3878SA14AV der Maschinenlärminformations- verordnung 3. GSGV, 18.01.1991 entspricht: Der höchste Schalldruckpegel beträgt 70 dB (A) oder weniger gemäß EN27779-1991.

Warning: This is a product which meets Class A of EN55022 and AS/NZS3548. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

FM-2

User’s Manual