Setting Up
☞
Setting Up |
|
This section describes how to assemble the printer and connect the |
|
power cord after choosing a suitable location for the printer and | GETTING |
checking that you received all the parts. | STARTED |
|
|
This printer is shipped with the print unit mounted and protective materials attached. Be sure to remove the two protective materials from the print unit. This operation is possible with the print unit mounted. First prepare and install the following two components:
• Print unit (photoconductor drum, developing unit, etc.)
• Toner bottle
The toner bottle first installed after you purchase the printer will last about 2500 printed pages under the condition of 5% coverage on A4 paper. The succeeding toner bottles last about 5000 printed pages each.
Notice:
Do not touch any connector contacts and corona wires to avoid possible electrostatic damage to the printer.
Be careful with the print unit’s drum (the green surface). The drum is easily damaged by contamination or by exposure to light for more than three minutes. Follow these guidelines:
•Never touch or scratch the drum surface.
•When the print unit is not in the printer, store it in a dark place or cover it with a clean sheet of paper.
•When the print unit is in the printer, keep the printer top cover closed. If you must work inside the printer for more than three minutes, remove the print unit with the toner bottle mounted and store it in a dark place.
User’s Manual |