Agilent Technologies 2712A, 2948 manual Operation Verification, Fl Channel Config

Instrument Changes Model 8904A

Cable Routing

1.Refer to figures 7-1,7-2 and 7-3. Remove the BNC connector ends from the front panel one at a time and insert them into the corresponding openings in the rear panel.

2.After all of the connectors have been transferred to the rear panel, secure the cables to the side rail as shown in figure 7-3using the new cable ties.

3.Install one new lock washer and one new nut on each connector.

4.Tighten the nuts on the BNC connectors hand tight using the nut driver. (The holes in the panel are D shaped and therefore prevent the connector from turning without having to tighten the nuts excessively.)

5.Verify that the SMC connections on the A3 Output Assembly and, if the instrument has Option 002, the A10 Output Assembly are tight.

Final Steps

1.Insert the new plastic hole-plugs into the front-panel output openings by carefully working the plugs into the holes with your fingers. The plugs fit tightly and will require some pressure to get them started in the holes.

2.Replace the bottom cover by reversing the removal procedure.

3.Type or write the date and option number on the new blank label in the following form: day/month/year : Opt . 004. Peel off the protective backing and stick the label on the rear panel. (Do not place the label over the existing serial number tag.)

Operation Verification

1.Connect the power cord and turn the instrument on.

2. The instrument should beep immediately upon power up and then again about 4.5 seconds later. The display should read

I * HP 8904A Main Selection Level * I

f l Channel Confie.

3.Key in the following keys. (This will set up 5 V dc on the OUTPUTS 1 HIGH connector and ground the LOW connector.)

fl (Channel Config.)

NEXT

SHIFT FLOAT=1 OFF

WAVE FORM

AMPTD 5 V

4.Connect a DC voltmeter, set to measure a 5 V dc signal, to the OUTPUTS 1 HIGH connector. The voltmeter should read approximately 5 V dc.

5.If the instrument is equipped with a second output, Option 002, key in

NEXT

SHIFT FLOAT 2 OFF

WAVE FORM 5=1

AMPTD 5 V

6.Connect the DC voltmeter to the OUTPUTS 2 HIGH connector. The voltmeter should read approximately 5 V dc.

7.Perform the AC and DC Amplitude Accuracy Test and the AC Amplitude Flatness Test. (Refer +,. the HP 8904A Operation and Calibration Manual.)

7-4 Front-to-Rear-Panel Output Conversion rev.15DEC89