Agilent Technologies 66lxxA Init Initcont 1 Initcont on, Listcoun Listcoun INF, Listcurr

Command Syntax	INITiate[:IMMediate]
	INITiate:CONTinuous <bool>
Parameters	For INIT[:IMM]	(None)
	For INIT:CONT	0 1 OFF ON
*RST Value	OFF
Examples	INIT INIT:CONT 1 INIT:CONT ON
Query Syntax	For INIT[:IMM]	(None)
	For INIT:CONT	INITiate:CONTinuous?
Returned Parameters	0 1
Related Commands	ABOR CURR:TRIG	TRIG *TRG VOLT:TRIG

List Subsystem

This subsystem controls the generation of parameter lists that sequence the power module output through values of voltage and current. Two subsystem commands specify lists of output voltages (LIST:VOLT), and currents (LIST:CURR). A count command (LIST:COUN) determines how many times the power module sequences through a list before that list is completed. A dwell command (LIST:DWEL) specifies the time interval that each value (point) of a list is to remain in effect. A step command (LIST:STEP) determines if a trigger causes a list to advance only to its next point or to sequence through all of its points.

Each list can have from 1 to 20 points. Normally, voltage, current, and dwell lists must have the same number of points, or an error is generated when the first list point is triggered. The exception is a list consisting of only one point. Such a list is treated as if it had the same number of points as the other lists, with all the points having the same value as the one specified point.

Note	All list subsystem commands (as well as CURR:MODE LIST and VOLT:MODE LIST) are implied
	ABORt commands.

LIST:COUN

This command sets the number of times that the list is executed before it is completed. The command accepts parameters in the range 1 through 9.9E37, but any number greater than 65534 is interpreted as INFinity. Use INF if you wish to execute a list indefinitely.

Command Syntax	[SOURce]:LIST:COUNt <NRf+>
Parameters	1 to 9.9E37 INFinity
*RST Value	1
Examples	LIST:COUN 3	LIST:COUN INF
Query Syntax	[SOURce]:LIST:COUNt?
Returned Parameters	<NR3>
Related Commands	CURR:MODE LIST:CURR LIST:DWEL LIST:STEP
	LIST:VOLT	VOLT:MODE

LIST:CURR

This command specifies the output current points in a list. The current points are given in the command parameters, which are separated by commas. Up to 20 points may be entered and the output current values specified by the points will be generated in the same order as they were entered.

Command Syntax	[SOURce]:LIST:CURRent <NRf+> {,<NRf+>}
Parameters	See Table 3-2
Default Suffix	A
Examples	LIST:CURR 2.5,3.0,3.5 LIST:CURR MAX,2.5,MIN
Query Syntax	(None)
Related Commands	CURR:MODE LIST:CURR:POIN? LIST:DWEL

Language Dictionary 37