OPERATION
Gearbox Noisy | Rough gears. | Run in or change gears. |
| Worn bearing. | Replace bearing |
Gear Box Leaking | Damaged oil seal | Replace Seal. |
| Bent shaft. | Replace oil seal and shaft. |
| Shaft rough in oil seal area. | Replace or repair shaft. |
| Oil seal installed wrong. | Replace seal. |
| Oil seal not sealing in the housing. | Replace seal or use a sealant |
|
| on OD of seal. |
| Oil level too high. | Drain oil to proper level. |
| Sand hole in casting. | Replace castings or gear box. |
| Gasket damaged. | Replace gasket. |
| Bolts loose. | Tighten bolts. |
Clutch Slips Excessively | Clutch linings badly worn or | Repair clutch per maintenance |
| plates warped. | section of manuals. |
| Too much power for clutch. | Reduce ground speed and material |
|
| intake. |
| Oil on facings. | Replace facings. |
| Friction facings glazed. | Clean with emery cloth. |
Blade Wears Too Fast | Cutting in sandy conditions. | Increase cutting height. |
| Cutting in rocky conditions. | Increase cutting height. |
| Soft "will fit" blades. | Use genuine Alamo HT blades. |
Hydraulic Cylinder Will Not Op. Not enough pressure. | Check pressure. | |
| Valve not connected properly. | |
| Quick coupler not completely | Complete connection. |
| connected. |
|
EAGLE 15 03/09 | Operation Section |
©2009 Alamo Group Inc.
