Alamo EAGLE 10/15 manual CAT IV Wing Driveline Shields

MAINTENANCE

MAINTENANCE

CAT IV WING DRIVELINE SHIELDS

To remove the main inner driveline shield, Remove the locking screws. Align the bearing tabs with the cone pockets. FIGURE Mnt-0026.Remove the half-guard and remove the bearing ring. FIGURE Mnt-R-0012.

Inspect the driveline shield for worn areas or cracks. If the shield has any dents or cracks, replace the Shield. While the Shields are off, examine the Driveline for signs of abnormal wear, bent or twisted shafts, or cracks in the shafts or tubes. Check to see that the Drivelines telescope easily. If the Drivelines do not telescope properly or show signs of abnormal wear, the shaft should be repaired or replaced.

To assemble the main inner driveline shield, grease the yoke groove and inner profile tube. Attach the bearing ring in groove with recesses facing profile tube. FIGURE Mnt-0027.Slide on the half shield. Turn the cone until it engages correctly. Install locking screws. FIGURE Mnt-0028.

IMPORTANT! Check that Guard Missing decal on steel under inner guard and

Rotating Driveline Decal are firmly affixed, undamaged and readable. If not, replace.

EAGLE 15 03/09 Maintenance Section 5-8

©2009 Alamo Group Inc.