Alamo EAGLE 10/15 manual Drivelines, Mnt-R-0031

MAINTENANCE

MAINTENANCE

DRIVELINES

The Drivelines and U-Joints should be inspected each morning before the Cutter is started. MntP-R-0006 and

Mnt-R-0031.

The U-Joint and CV Joint on the Driveline undergo extreme forces when the unit is turning or when the Wings are being raised. It is important that the U-Joints and CV Joint be greased each day before the unit is started. The U-Joints are located at each end of the Center and Wing Drivelines. The CV Joint is located at the end of the Main Driveline. The U-Joint and CV Joint assemblies are accessible by rotating the Driveline Safety Shield until the hole in the Shield matches up with the Grease Fitting. Use #2 Bearing Grease for lubrication. Inspect the U-Joint for wear by holding the shaft on one side of the U-Joint while trying to rotate the shaft on the other side of the U-Joint. If there is noticeable movement in the Driveline replace the U-joint before it causes severe damage to the Driveline.

LOCATION	EXTENDED LUBE		LEVER
	INTERVAL		ACTION PUMPS
Cross & Bearings (Main CV)	50	Hours	4	- 6
Cross & Bearings (Non CV, Intermediate, Wing)	8	Hours	4	- 6
Telescoping Members	8	Hours	4	- 6
CV Center Housing	8	Hours	8	- 12

EAGLE 15 03/09 Maintenance Section 5-6

©2009 Alamo Group Inc.