Alamo EAGLE 10/15 Maintenance and Service Safety Instructions and Practices

SAFETY

EAGLE 15 03/09 Safety Section 1- 15

SAFETY

Maintenance and Service Safety Instructions and Practices

Secure the Implement for transport before traveling on public roads. For pull-type

Implements , secure th e ce nter axle u sing cylinder sto p s or transport p in and properly attach

a safety chain between the Implement and Tractor. Secure wings in upright position on

folding Implements using wing transport locks. (STI-7)

Always keep a careful lookout and use extreme care when working

around overhead obstructions and electrical power lines. The

Implement wing can be over 10 feet high. Never allow the Implement

wing to come within 10 feet of any power line. (STI-8)

Your driving vision may be reduced or impaired by the tractor, cab, or implement. Before

driving on public roadways identify any limited vision areas, and make adjustments to your

operating position, mirrors, and the implement transport position so that you can clearly

see the area where you will be traveling, and any traffic that may approach you. Failure to

maintain adequate vision of the public roadway and traffic can result in serious injury or

even death. (STI-10)

Make sure the PTO shield, integral driveline shields, and input shields

are is installed when using PTO-driven equipment. Always replace any

shield if it is damaged or missing. (S3PT-8)

Relieve hydraulic pressure prior to doing any maintenance or repair work

on the Implement. Place the Implement on the ground or securely

blocked up, disengage the PTO, and turn off the tractor engine. Push

and pull the Remote Cylinder lever in and out several times prior to

starting any maintenance or repair work. (S3PT-09)

Always disconnect the main PTO Driveline from the Tractor before performing service on

the Implement. Never work on the Implemen t with th e tractor PTO driveline connected and

running. Rotating Parts, Blades or Drivelines could turn without warning and cause

immediate enta nglement, injury or death. (S3PT-11)

Never interfere with factory-set hydraulic calibrations. Any change in calibration could

cause a failure of the eq uip m en t an d may re sult in inju ry. (SBH-13)

Always maint ain the safety signs in good r eadable conditio n. If the safety signs are missing,

damaged, or unreadable, obtain and install replacement safety signs immediately. (SG-5)