Alamo EAGLE 10/15 manual Assembly of Power Divider

MAINTENANCE

MAINTENANCE

Assembly of Power Divider

STEP 1

Install the Bearing Race into the Hub cap.

STEP 2

Install the Bearing on the Output Shaft. FIGURE Mnt-R-0054.Place the Shaft into the Hub Cap. FIGURE Mnt- R-0055.Place the Bearing (FIGURE Mnt-R-0056)on the Shaft and drive it down. Place the Gear (FIGURE Mnt-R-0057)on the Shaft.

STEP 3

Apply some Locktite on the Adjusting Nut (FIGURE Mnt-R-0059). Install the Adjusting Nut onto the Shaft. Tighten the Nut until it is difficult to turn the Shaft. FIGURE Mnt-R-0060.Check to be sure that the Retaining Ring is fully engaged in the counter bore. While holding Hub, tap each end of Shaft and check to see if it has

EAGLE 15 03/09 Maintenance Section 5-24

©2009 Alamo Group Inc.