OPERATION

3. TRACTOR REQUIREMENTS

The tractor used to operate the mower must have the power capacity to lift, pull, and operate the Power Take Off (PTO) at the mower’s rated speed while traveling at a ground speed between 2 and 5 MPH. Operating the mower with a tractor that does not meet the following requirements may cause tractor or mower damage and be a potential danger to the operator and passersby.

Tractor Requirements and Capabilities

ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.

Tractor Safety Devices

Slow Moving Vehicle (SMV) emblem, lighting,

 

 

PTO master shield

Tractor Horsepower -Minimum

Eagle 10 40HP; Eagle 15 50HP

-Maximum

540 RPM Unit-100 HP; 1000 RPM Unit 140 HP

Drawbar

Set length according to operating speed of the mower and driveline

 

type, rated to carry weight of the mower, safety chain attachment point

Tongue Weight

2100 lbs.

Hydraulics

Minimum of 1 hydraulic port (extra 3-spool valve required). Minimum

 

2 ports, 3 ports recommended if additional,3-spool control valve is not used.

Front End Weights

As needed to maintain 20% weight on front axle

Power Take Off

Operating speed and shaft size depends on operating speed and

 

driveline type of the mower.

 

Tire Wheel Spacing

Set tires minimum width of 60” from inside to inside of tires.

3.1 ROPS and Seat Belt

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened. Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an authorized dealer. OPS-U- 0003

Operate this Equipment only with a Tractor equipped with an approved roll- over-protective system (ROPS). Always wear seat belts. Serious injury or even death could result from falling off the tractor--particularly during a turnover when the operator could be pinned under the ROPS. (SG-7)

3.2 Tractor Safety Devices

If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor warning signals are obscured.

Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO with the PTO master shield missing or in the raised position. OPS-U- 0004

Tractor Horsepower

EAGLE 15 03/09

Operation Section 4-5

©2009 Alamo Group Inc.

OPERATION

Page 99
Image 99
Alamo EAGLE 10/15 manual Tractor Requirements and Capabilities, Rops and Seat Belt, Tractor Safety Devices