ASSEMBLY
ASSEMBLY
General Assemby
Set up cutter as received from factory with these instructions. Refer to Parts Listing Section for further information when necessary
Select a suitable working area. Open parts box and lay out parts to make location easy. Refer to parts listing and exploded view drawings in the Parts Listing Section and the packing list.
Cut all wire ties, including those on blades if present.
This cutter is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hardware. Refer to Torque Chart when tightening hardware.
Position Center Section on a flat surface. Elevate approximately 10 inches from ground to permit the installation of Wing Sections.
Blade Carrier and Blades
Do not install Blades or do any work under the Cutter sections unless the section(s) are safely and securely blocked or latched in place.
The Blade Bolts must be tightened to 350 ft. lbs. torque before operating. NOTE: Blade Bolts have
To insure proper installation, check to see that Blade cutting surfaces are correct for counterclockwise rotation on the Center Section and on the Left Wing Blade Carrier. See FIGURE
Eagle 20 03/09 | Assembly Section |
© 2009 Alamo Group Inc.
