
ASSEMBLY
ASSEMBLY
Driveline Clamp Cone Yoke Operating Instructions
Loosen the yoke clamp cone with a 11/16” (17mm) wrench and remove the cone from yoke. Slide yoke onto the shaft and align hole for clamping cone with annular groove of gearbox shaft. Reinstall cone and tighten (75
NOTE: The clamping cone is serviced only as a complete assembly. Do not attempt to disassemble the clamping cone.
Canopy Shields
After final adjustment attach Canopy Shields over Divider Gearbox (FIGURE 26) , Secondary Gearbox (FIGURE 24 & 25).
Install all Canopy Shields over Torque Limiters and Drivelines and make certain they remain installed at all times when operating this Cutter.
Eagle 20 03/09 | Assembly Section |
© 2009 Alamo Group Inc.