Alamo Eagle 14, Eagle 20 manual 0071

MAINTENANCE

Install Bearing on the Shaft. On the opposite end of the Shaft, install one .012" and one .020" Gear Adjusting Shims. Install the Gear Spacer and the Gear. Install one .020" thick Gear Adjusting Shim and install the Bearing. FIGURE Mnt-R-0068-0069.

STEP 7

Install the Shaft Assembly into the Main Housing. FIGURE Mnt-R-0070.Install the Input Cap and check the gap between the Main Housing and the Input cap to determine the approximate amount of Shims that will be required. Remove the Input Cap and install the Gaskets. Reinstall the Cap and install four Bolts. FIGURE Mnt-

R-0071.

NOTE! These four Bolts should be installed in every other bolt hole of the Cap When tightening, the second bolt tightened should be 180 degrees away from the first bolt tightened. Check how the Input Shaft turns. When turned, if tight, additional Shims are needed. If loose and the Shaft can be moved from side to side, Shims need to be removed. The correct adjustment of the Input Shaft Bearings is when the Shaft turns freely, but cannot be moved from side to side in the Housing.

STEP 8

Eagle 20 03/09 Maintenance Section 5-27

© 2009 Alamo Group Inc.

MAINTENANCE