MAINTENANCE
Install the second Spindle Hub assembly on the Main Housing. Check the amount of backlash present between its Gear and the Gear on the Input Shaft. The amount of backlash between these two Gears needs to be set to the same amount that was set on the first Gear mesh. Add or subtract Shims as required. Once this adjustment is made, remove the Hub Cap and apply sealer as before, then reinstall on Housing. Install all eight bolts and tighten to a torque of 31 to 34 foot pounds. FIGURE
The assembly should now be filled with a good grade of NLGI 000 Grease.
Eagle 20 03/09 | Maintenance Section |
© 2009 Alamo Group Inc.
