bdiGDB for GNU Debugger, BDI2000 | User Manual 52 |
B Maintenance
The BDI needs no special maintenance. Clean the housing with a mild detergent only. Solvents such as gasoline may damage it.
If the BDI is connected correctly and it is still not responding, then the built in fuse might be damaged (in cases where the device was used with wrong supply voltage or wrong polarity). To exchange the fuse or to perform special initialization, please proceed according to the following steps:
!
Observe precautions for handling (Electrostatic sensitive device)
Unplug the cables before opening the cover.
Use exact fuse replacement (Microfuse MSF 1.6 AF).
11.1 Unplug the cables
BDI2000
Abatron AG Swiss Made
2
3
2.1Remove the two plastic caps that cover the screws on target front side (e.g. with a small knife)
2.2Remove the two screws that hold the front panel
| BDI TRGT MODE | BDI MAIN |
| BDI OPTION |
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3.1 While holding the casing, remove the front panel and the red elastig sealing
casing
elastic sealing
front panel
© Copyright | V 1.04 |
