Preliminary Information
About the Control
The UniLinc control on the
UniLinc allows the owner to program custom cycles, run diagnostic cycles and retrieve audit, error and bearing information.
IMPORTANT: It is extremely important that the
Power Failure Recovery
If a cycle is in progress when the power fails, and if the power outage lasts three or more seconds, the cycle is lost and cannot be resumed when power recovers. If the power outage lasts less than three seconds, the control will resume the cycle when the power recovers.
Communications
The control has the ability to communicate with a PDA or a laptop with an IrDA device running the UniLinc software. Devices such as PDAs and laptops that are IrDA capable (able to transmit information to machine) that have been tested and approved for use with the UniLinc software can be used as a tool for managing the machine.
Audit Information
The control collects and stores audit information, which can be accessed with a PDA. Refer to the following list for available audit information with a PDA. Refer to UniLinc PC and PDA Application User Instructions.
•Total Number of Individual Cycle Counters
•Last 25 Machine Cycles
•Service History
•Machine Errors Audit Data
•Communication Audit Data
•
•Power Failures Audit Data
•Average Fill Time Audit Data
•Average Drain Time Audit Data
•Power Failure Audit Data
The PDA can receive audit and program data from the control, and send programming data and diagnostic commands to the control. Refer to UniLinc PC and PDA Application User Instructions for additional information on using a PDA.
F8138801 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 13 |