Alliance Laundry Systems PHM1401C To Start a Cycle, NOTE: If door is not closed when the keypad, is pressed, display will jump to the Close Door Menu

To Start a Cycle

1.Press the or keypad to change cycles.

2.Press the keypad to move the cycle in the rightmost menu box to the center, highlighted position.

3.Press the keypad to move the cycle in the leftmost menu box to the center, highlighted position.

4.Moving the and keypads allows the Cycle Menu to scroll through the center, highlighted position.

5.Press to start selected cycle.

NOTE: Press and hold or keypad to make highlighted area move rapidly.

NOTE: If door is not closed when the keypad

is pressed, display will jump to the Close Door Menu.

NOTE: If the machine has operated over 200 hours and the Lubricate Bearings has not been reset from the System Menu the Global Settings, a reminder screen will pop up. The Lubricate Bearings Menu will be display for five seconds and the Cycle Menu will display for five seconds. This will occur until the Bearing Timer is reset in the System Menu. The Lubricate Bearings Menu will only be shown during the Cycle Menu.

Every night at midnight the control will enter Service Schedule Menu if the machine is in idle mode on the Cycle Menu.

When a keypad is pressed or the door is opened or an IR communication takes place the control will turn the LCD contrast on and the backlight back on (if programmed).

Control will also enter specific service sub-menu for that day.

Quarterly Menu displays on the first day of the month for January, April, July and October.

Monthly Menu displays on all other first days of the month.

Weekly Menu displays on a Monday not on the first day of the month. All other days the control will display the Daily Menu.

Machine Cycle Definition and Operation

Press any keypad to clear the menu and enter Cycle Menu.

Optional settings are performed by either pressing a keypad or by a combination of keypad presses:

•Press the keypad to jump control to the Contrast Adjust/Backlight Menu.

•Press the keypad to enter the Service Schedule Menu.

•Press and hold then to enter Delayed Start Menu.

•Press and hold then then to enter the System Menu.

•Press the keypad on the Cycle Menu to unlock door.

A Banner is displayed above the Cycle Selections in the Cycle Menu. If Banner 1 and Banner 2 are programmed, Banner 1 displays for ten (10) seconds and Banner 2 displays for ten (10) seconds. If only one Banner is programmed it will be the only one shown. Refer to Banner Menu Section.

During communication with the PDA, all menus enter IR Communications Menu.

F8138801