Alpine VPA-B222R owner manual Getting Started, Feature Accessory List, Initial System Start-Up

Getting Started

Joystick

Flipper switch

Operation is carried out by the commander. If an Alpine touch panel monitor is connected to this unit, the soft buttons appear in the display to enable touch operation.

This manual explains operation using the commander. For details of the touch operation, refer to “Soft button operation” on page 40.

•The commander vibrates when an operation is performed. Refer to “Turning the Commander Vibration ON or OFF” (page 14).

Feature

If an Alpine Ai-NET compatible products (DVD player, DVD/CD changer, Adapter for iPod, etc.) is connected to the VPA-B222R, it can be controlled from the commander and displayed on the external monitor. If an optional Alpine Navigation System is connected to the VPA-B222R, the Navigation screen will be displayed on the external monitor, and its operation can be performed. For details on the function of connected devices, refer to the Owner’s Manual.

Accessory List
Main unit	1
Power cable	1
Parking brake sub-lead	1
Factory System Cable	1
ISO power cable	1
Pinch connector	6
Bracket	2
Tapping screw (M4 × 14)	4
Pan screw (M4 × 8)	4
Velcro fastener	2
RGB cable (3M)	1
RCA extension cable (6M)	1
Antenna extension cable (5.5M)	1
Commander	1
Holder	1
Commander connection cable (5.5M)	1
Double-sided adhesive tape	1
Reinforcement screw	3
Cable clamp	3

Initial System Start-Up

Be sure to press the RESET button when using the unit for the first time, after installing the CD changer, after changing the car battery, etc.

1 Turn off the unit power.

2 Press RESET with a ball-point pen or similar pointed object.

RESET

Turning Power On or Off

Some of this unit’s functions cannot be performed while the vehicle is in motion. Be sure to stop your vehicle in a safe location and apply the parking brake, before attempting these operations.

1 Press SOURCE/POWER to turn on the unit.

•The unit can be turned on by pressing any button.

2 Press and hold SOURCE/POWER for at least 2 seconds to turn off the unit.

Displaying the Unit Source on the Monitor

By selecting the image source on the unit, it can be displayed on a connected monitor. For operation, refer to the Owner’s Manual of the monitor.

If an Alpine monitor is connected (RGB connection)

1Recall the navigation mode by selecting the image source on the monitor.

The source of the unit is displayed.

Switching a Source

1 Press SOURCE/POWER.

The source selection screen is displayed.

Screen example

Displays source modes that can be selected

(The kind of source modes that are displayed varies depending on connection and setting)

2 Press the joystick up or down to select the desired source, then press / /ENTER.

The selected main source screen is displayed.

•In the source selection screen mode, press TA/RTN/SETUP to return to the previous screen.

6-EN