American Power Conversion AP9207 manual Characters long, and is case-sensitive, Entries, Menu, on

Using the Management Port continued

Connecting to the Management port (via modem)

To connect a modem to Share-UPS, use a standard serial cable. Connect one end to the Management port of Share- UPS and the other end to the serial port of the modem.

When Share-UPS is powered on, it configures the con- nected modem by sending modem AT setup commands.

If your modem requires an external power adapter, plug it into the UPS so that it will operate during power failures.

Logging on to	To log on to Share-UPS, perform the following steps in the
Share-UPS	order given.
	1 Set the communication parameters of the modem
	or DTE to 8 data bits, no parity, 1 stop bit, no flow
	control. When logging on for the first time, set the
	baud to 9600 bps, the Share-UPS default. (Share-
	UPS supports 1200, 2400, 9600, and 19200 baud.)
	2 Press CTRL + P. Share-UPS then prompts you for
	the password.
	3 Enter the password for Share-UPS. The default
	password from the factory is APC (upper case).
	The Share-UPS Main menu appears.
	Note: The password may be as many as eight
	characters long, and is case-sensitive.
	Share-UPS hangs up the modem, if con-
	nected, after three unsuccessful password
	entries.
	For security, change the password as soon
	as possible. See “Share-UPS Settings
	Menu,” on page 40.

31