AMSTRAD DDI-1 FOUNDATION COURSE

Foundations 1: Setting Up

Connecting the Mains Lead

The Amstrad disc drive operates from a 220-240V ~50Hz Mains Supply.

The Mains Lead is fitted at the rear of the unit. Fit a proper Mains Plug to the Mains Lead. If a 13 Amp (BS1363) Plug is used, a 3 Amp fuse must be fitted. The 13 Amp Fuse supplied in a new Plug must NOT be used. If any other type of Plug is used, a 5 Amp Fuse must be fitted either in the Plug or Adaptor or at the Distribution Board.

IMPORTANT

The wires in this Mains Lead are coloured in accordance with the following code:

Blue : Neutral

Brown: Live

As the colours of the wires in the Mains Lead of this apparatus may not correspond with the coloured markings identifying the terminals in your Plug, proceed as follows:

The wire which is coloured Blue must be connected to the terminal which is marked with the letter 'N' or coloured Black.

The wire which is coloured Brown must be connected to the terminal which is marked with the letter 'L' or coloured Red.

Disconnect the Mains Plug from the Supply Socket when not in use.

Never attempt to remove any screws, or open the case of the disc drive. Always obey the warning on the Rating Label which is located underneath the case of the disc drive:

WARNING LIVE PARTS INSIDE. DO NOT REMOVE ANY SCREWS

The POWER ON/OFF switch for the disc drive(s) is located on the rear panel of the unit.

Always ensure that any discs are removed from the drive(s) before switching the POWER switch ON or OFF.

Always switch the disc drives' POWER switch ON before switching the computer's POWER switch ON.

Foundation 1.1

AMSTRAD Disc Drive & Interface DDI-1 Manual

Page 7
Image 7
Amstrad DDI-1 manual Foundations 1 Setting Up, Connecting the Mains Lead