Connecting the DDI-1 to the Computer

1.Check that the computer and disc drive(s) are switched off.

2.Plug the Interface Unit firmly into the edge-connector marked FLOPPY DISC at the rear of the computer (See Figure 1)

Rear of Computer

Interface Unit

Figure 1

3.At the end of the ribbon cable from the Interface Unit, you will find a plug which is to be used for connecting to the main disc drive (Drive A), see Figure 2.

The plug which you will find slightly further back in the cable (see Figure 2) is to be used only for connecting to a second disc drive (Drive B); i.e. if you have purchased an additional Amstrad FD-1.

Ribbon

Connector Plug toCable Main Disc Drive

(Drive A)

Interface Unit

Connector Plug to

Second Disc Drive Figure 2 (Drive B)

AMSTRAD Disc Drive & Interface DDI-1 Manual

Foundation 1.2

Page 8
Image 8
Amstrad manual Connecting the DDI-1 to the Computer