AMX MAX-CSE, MAX-CSD10 manual IR/Serial Send_Commands Cont, NetLinx Programming, Description

NetLinx Programming

IR/Serial Send_Commands (Cont.)

Command	Description
POD	Channel 255 changes are enabled. This command is used in conjunction with
Disable previously active	the I/O Link command.
	Syntax:
'PON' (power on) or 'POF'
(power off) command	SEND_COMMAND <DEV>,"'POD'"
settings.
	Example:
	SEND_COMMAND IR_1,"'POD"
	Disables the 'PON' and 'POF' command settings on the IR_1 device.
POF	If at any time the IR sensor input reads that the device is ON (such as if
Turn Off a device connected	someone turned it on manually at the front panel), IR function 28 (if available)
	or IR function 9 is automatically generated in an attempt to turn the device back
to an IR port based on the
	OFF. If three attempts fail, the IR port will continue executing commands in the
status of the corresponding
	buffer.
I/O Link input.
	If there are no commands in the buffer, the IR port will continue executing
	commands in the buffer and trying to turn the device OFF until a 'PON' or 'POD'
	command is received. If the IR port fails to turn the device OFF, a PUSH and
	RELEASE is made on channel 254 to indicate a power failure error. You can
	only use the 'PON' and 'POF' commands when an IR device has a linked
	I/O channel. Channel 255 changes are disabled after receipt of this command.
	You can only use the 'PON' and 'POF' commands when an IR device has a
	linked I/O channel.
	Syntax:
	SEND_COMMAND <DEV>,"'POF'"
	Example:
	SEND_COMMAND IR_1,"'POF'"
	Sends power down IR commands 28 (if present) or 9 to the IR_1 device.
PON	If at any time the IR sensor input reads that the device is OFF (such as if one
Turn On a device connected	turned it off manually at the front panel), IR function 27 (if available) or IR
	function 9 is automatically generated in an attempt to turn the device back ON.
to an IR port based on the
	If three attempts fail, the IR port will continue executing commands in the buffer
status of the corresponding
	and trying to turn the device On.
I/O Link input.
	If there are no commands in the buffer, the IR port will continue trying to turn
	the device ON until a 'POF' or 'POD' command is received. If the IR port fails to
	turn the device ON, a PUSH and RELEASE is made on channel 254 to indicate
	a power failure error.
	You can only use the 'PON' and 'POF' commands when an IR device has a
	linked I/O channel. Channel 255 changes are disabled after receipt of this
	command.
	Syntax:
	SEND_COMMAND <DEV>,"'PON'"
	Example:
	SEND_COMMAND IR_1,"'PON'"
	Sends power up IR commands 27 or 9 to the IR_1 port.

102 MAX-CSE/MAX-CSD10 Operation/Reference Guide