AMX MAX-CSD10 manual Configuring the MAX-CSEfor communication, Displaying Stream Content

Displaying Stream Content

4.Press the System Settings button (located on the Protected Setup page) to open the System Settings page and obtain the IP information from the IP Address field (FIG. 41).

Modero IP Address information

FIG. 41 System Settings page

Configuring the MAX-CSE for communication

1.Complete the procedures outlined within the Configuring the MAX Communication Parameters section on page 52 to establish an active connection to the source MAX-CSE.

2.Confirm the MAX-CSE is properly configured to use the newly established Static IP Address by launching your browser and entering the MAX’s new Static IP Address into the browser’s Address field.

3.Press the Enter key on your keyboard to initiate the communication process and launch the initial on-screen Enter Network Password security dialog.

4.Enter the words administrator and password (if using the default login profile) into the corresponding User Name/Password fields. This is the factory default security login information.

5.Click OK to enter the information and proceed to the Administration page which provides both a descriptive overview of the program stream and lists the currently used firmware.

6.Determine the data throughput available on the network being used by the source encoder. This information determines which Encoder Profile and Transport Protocol will be used to encode the outgoing media stream.

MAX-CSE/MAX-CSD10 Operation/Reference Guide 69