AMX MAX-CSD10 manual Ethernet/RJ-45Port: Connections and Wiring, Ethernet RJ-45Pinouts and Signals

MAX-CSE and MAX-CSD10 Installation

•ETHERNET:RJ-45 connector routes streamed Audio/Video and Data out to an external device capable of receiving the streamed media content (including a MAX-CSD10, VG-Series touch panel, or computer).

The Power-over-Ethernet (PoE) feature of the Ethernet port can be used to provide indirect DC power to this 802.3af-compliant device over the unused wire pairs in the UTP or STP Ethernet cable (RJ-45 pins 4, 5, 7, and 8).

•AUDIO IN:Stereo line-level input via two rear RCA connectors (R/L).

• MIC IN:	Stereo line-level input via a rear 1/8” mini-stereo jack.
• IR:	2-pin 3.5 mm mini-Phoenix connector accepts a single IR Emitter
	(CC-NIRC) and can connect one IR- or Serial-controllable device.
• I/O:	4-pin 3.5 mm mini-Phoenix connector allows for the connection of up
	to two devices. The I/O port responds to either switch closures,
	voltage level (high/low) changes, or can be used for logic-level
	outputs. When used for outputs, the I/O port acts as a switch to GND.

Ethernet/RJ-45 Port: Connections and Wiring

The following table lists the pinouts, signals, and pairing for the Ethernet connector.

Ethernet RJ-45 Pinouts and Signals

Pin	Signals	Connection		Pairing		Color
			s
1	TX +	1	--------- 1	1 ---------	2	Orange-White
2	TX -	2	--------- 2			Orange
3	RX +	3	--------- 3	3 ---------	6	Green-White
4	no connection	4	--------- 4			Blue
5	no connection	5	--------- 5			Blue-White
6	RX -	6	--------- 6			Green
7	no connection	7	--------- 7			Brown-White
8	no connection	8	--------- 8			Brown

FIG. 6 diagrams the RJ-45 pinouts and signals for the Ethernet RJ-45 connector and cable.

FIG. 6 RJ-45 wiring diagram

MAX-CSE/MAX-CSD10 Operation/Reference Guide 13