Displaying Stream Content
10.From the Stream section of the page, locate the Transport Protocol field and use the
An UDP protocol is typically used with
An RTP protocol is typically used both with
11.Enter the previously obtained IP Address of the target Modero panel (FIG. 41) into the Target Address field.
12.Enter a numeric value into the Target Port field. This field corresponds to the port on the destination device to which the outgoing video (audio/video) stream is being directed.
It is recommended that this value not currently be used by another port on the target device. It is recommended that the following ports also not be used: 21, 22, 23, 80, 443, and 1319. For the purposes of these procedures, we’ve chosen to use 5000 as the video Target Port.
13.If using RTP as a Transport Protocol, enter a value into the Target Audio Port field. This field corresponds to the port on the destination device where the audio only portion of the stream is being directed to. This value cannot match the value entered into the Target Port field above. If using UDP as a Transport Protocol, this field becomes
For the purposes of these procedures, we are not required to enter a Target Audio Port value because the A/V content is not begin streamed separately.
14.Click the Apply button to save the encoding profiles to the
If using RTP, both the Target Port and Target Audio Port must be different and should use even numbers.
71 | |
|
|