AMX MAX-CSD10 manual Configuring the MAX-CSEAudio/Video Inputs, Displaying Stream Content

Displaying Stream Content

Configuring the MAX-CSE Audio/Video Inputs

1.Complete the MAX-CSE connection and wiring procedures outlined within the Wiring the MAX- CSE Connectors and Cables section on page 12.

2.Access the A/V Setup page (FIG. 43) by clicking the Audio/Video button in the Navigation Bar. This page provides the user with the ability to select the source of the incoming video signal (from either the rear Composite or S-Video port), the format of the incoming video (NTSC/PAL), and the gain given to the incoming audio signal.

FIG. 43 A/V Setup page

3.From within the Video section of this page, check off the appropriate Video In and Video Port radio boxes which correspond to both the type of video signal being used and its associated format.

For the purpose of these procedures, we’ve chosen to feed an NTSC signal into the rear Composite video connector. As a result, a user should "check-off"/select both the Composite and NTSC radio boxes.

4.If you are feeding a microphone audio signal into the rear MAX-CSE microphone connector, you could use the Microphone Gain field to enter an audio level (0 - 99) associated with the gain used by the rear microphone input.

At any time, the user can choose to mute the incoming microphone signal by either toggling the state of the Microphone icon located at the top of the page or entering a value of zero into the Mic Gain field.

5.Click the Apply button to save the encoding profiles to the MAX-CSE.

72 MAX-CSE/MAX-CSD10 Operation/Reference Guide