Configuring Communication
Configuring the MAX Communication Parameters
Although the unit is initially configured to obtain the first available DHCP Address, it is recommended that after the initial connection, the unit be setup to use a Static IP Address. Using a Static IP Address for both the source and destination devices can be beneficial for both diagnostic and direct access purposes.
MAX Products are not designed or intended to, and may not be used to, violate anyone’s copyright or other intellectual property rights. Each user of the MAX Products may only use the products in connection with materials legally owned or licensed by such user and only to the extent such ownership or license rights permit such use.
Obtaining the Unit’s Initial DHCP Address
1.Connect an Ethernet cable to the unit’s rear Ethernet connector.
2.Connect the
The
Server and obtain a valid DHCP Address.
3.After the unit has successfully obtained an IP Address from the DHCP Server, it then displays this obtained DHCP Address across the front LCD (FIG. 32).
FIG. 32 Example of the current IP Address
4.Write down the newly obtained DHCP Address displayed on the front panel LCD.
Communicating with the Unit via the
To facilitate communication with the
1.Launch your web browser.
2.Enter the IP Address of the target unit (ex: http://192.199.99.99) into the web browser’s Address field.
52 |