AMX MAX-CSE, MAX-CSD10 Obtaining the IP Address of the Target Computer, Displaying Stream Content

Displaying Stream Content

Setting up a Computer to Receive and Display a Stream

The MAX-CSE must first be configured to target a specific computer and a specific set of ports on that target machine so that the third-party player has content to receive and display on-screen.

Obtaining the IP Address of the Target Computer

1.On your PC, click Start > Run to open the Run dialog.

2.Enter cmd into the Open field and click OK to open the command DOS prompt.

3.From the C:\> command line, enter ipconfig to display the current IP Address of the PC. The information displayed includes the DNS Suffix, IP Address, Subnet Mask, and Default gateway.

Configure the MAX-CSE for Communication to a Computer

1.Complete the first 10 steps described in the previous Configuring the MAX-CSE for communication section on page 69.

2.From the Stream section of the page, locate the Transport Protocol field and use the drop-down arrow to select a desired protocol. For the purposes of these procedures, select UDP as the protocol.

An UDP protocol is typically used with higher-bandwidth streams and only requires the entry of a single Target Port because both the video and audio are combined into a single media stream. With this method, the user will only need to launch one instance of the third-party player because BOTH signals are fed into the application as part of the same stream.

An RTP protocol is typically used both with lower-bandwidth streams and when user wants to purposely separate the video and audio information into two distinct streams. With this method, the user will only need to launch two instances of the third-party player because EACH signal is fed to the target computer as its own separate stream. Once instance will display the video whereas the second instance will provide the corresponding audio.

3.Enter the previously obtained IP Address of the target computer into the Target Address field.

4.Enter a numeric value into the Target Port field. This field corresponds to the port on the destination device where the outgoing video (audio/video) stream is being directed to. It is recommended that the value being entered is not currently in use by another port on the target device.

It is recommended that the following ports not be used: 21, 22, 23, 80, 443, and 1319. For the purposes of these procedures, we’ve chosen to use 5000 as the video Target Port.

5.If using RTP as a Transport Protocol, enter a value into the Target Audio Port field. This field corresponds to the port on the destination device where the audio only portion of the stream is being directed to. This value can not match the value entered into the Target Port field above. If using UDP as a Transport Protocol, this field becomes greyed-out and unused since the both the audio and video content is being combined into a single stream.

For the purposes of these procedures, we are not required to enter a Target Audio Port value because the A/V content is not begin streamed separately.

6.Click the Apply button to save the encoding profiles to the MAX-CSE.

If using RTP, both the Target Port and Target Audio Port must be different.

7.Complete the media configuration procedures outlined within the previous Configuring the MAX- CSE Audio/Video Inputs section on page 72.

76 MAX-CSE/MAX-CSD10 Operation/Reference Guide