| Table of Contents |
MAX vs. NetLinx Master - Functional Overlap | 63 |
Verifying the MAX’s Current Version of Firmware - via the UI | 63 |
Verifying the MAX’s Current Version of Firmware - via Studio | 64 |
Upgrading MAX Firmware | 64 |
Upgrading | 64 |
Upgrading | 65 |
Upgrading the MAX’s Firmware - via NetLinx Studio | 65 |
Displaying Stream Content | 67 |
Overview | 67 |
Requirements for Receiving Streamed Content | 67 |
Setting up a Modero Panel to Receive and Display a Stream | 68 |
Obtaining the IP Address of the Target Panel | 68 |
Configuring the | 69 |
Configuring the | 72 |
Setting up a streaming page within TPDesign4 | 73 |
Establishing the Final Connection Between the Two Units | 75 |
Setting up a Computer to Receive and Display a Stream | 76 |
Obtaining the IP Address of the Target Computer | 76 |
Configure the | 76 |
Establishing the Final Connection Between the CSE and Computer | 77 |
NetLinx Programming | 79 |
Device:Port:System (D:P:S) | 79 |
Port Assignments | 79 |
80 | |
88 | |
95 | |
RS232/422/485 Ports Channels | 98 |
98 | |
IR / Serial Ports Channels | 99 |
IR/Serial Port (Port 3) Commands | 100 |
I/O Port Commands (Port 4) | 106 |
IR RX Port Channels (Port 5) | 106 |
LCD Commands (Port 6) | 107 |
iii | |
|
|