AMX NXD-1000Vi manual Installing the NXD into a Flat Surface using #4 screws

Installation

The drywall clip set must be re-ordered from AMX if the drywall clip is bent accidentally during an installation or removed during a re-installation.

10.Tighten all three drywall clip sets (screws and clips) until the entire Mounting Tab is securely fastened and flush against the wall.

11.Place the Faceplate/Trim Ring assembly (A in FIG. 23) back onto the main NXD unit

(B in FIG. 23). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front faceplate/bezel.

12.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.

13.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

Installing the NXD into a Flat Surface using #4 screws

Mounting screws (#4-40, included) are secured through two sets of circular holes located at the left and right sides of the NXD-1000Vi. The most important thing to remember when mounting the NXD

Wall Mount is that the outer frame (Mounting Tabs) must be installed flush against the mounting surface.

Refer to SP-2259-03for detailed installation dimensions (reproduced in FIG. 24).

It is recommended that you cutout the surface slightly smaller than what is outlined in the installation drawings so that you can make any necessary cutout adjustments.

1.Prepare the area by removing any screws or nails from the surface before beginning the cutout process.

2.Cut out the surface for the NXD Wall Mount unit using the dimensions shown in FIG. 24.

10" Modero Widescreen Touch Panels 33