APC 10-40 KVA 380/400/415 V

9Smart-UPS VT ® 10-40 kVA 380/400/415 V, 208/220 V, 200/208 V Battery Installation

Note: The U-shaped interconnection brackets are 1-2 mm higher than the opening below the

enclosure to inactivate the casters. Therefore, the enclosure must be tilted when placing the U-

shaped interconnection brackets under the enclosure.

3. In each side of the same enclosure insert a

maximum of nine and a minimum of two M8

screws (not provided) through holes in the

bottom of the enclosure and through holes in the

U-shaped floor anchoring brackets, and into the

pre-drilled floor holes.

Note: See “Prepare for Floor-Anchoring

(optional)” on page2 if the floor has not been prepared for anchoring.

4. Fasten the screws.

5. Move the adjacent enclosure on its

casters close to the enclosure with the U-

shaped floor anchoring brackets.

Note: If the additional enclosure is on

its levelling feet, use a forklift or pallet jack to move it into position.









Contents

Main Page Contents Safety ............................................................................... 1 Prepare for Floor-Anchoring (optional) ........................ 2 Prepare for Cables .......................................................... 5 Run the Cables.............................................................. 11 Page Safety Prepare for Floor-Anchoring (optional) System arrangements Hole positions for a stand-alone UPS enclosure with L-shaped anchoring brackets Hole positions for up to four UPS units in parallel with U-shaped anchoring brackets. Note: Recommended minimum number of floor screws for the below two configurations is 10. Model width: 352 mm (13.85 in). Model width: 523 mm (20.59 in). Prepare for Cables Remove the front panel Remove the top cover Page Remove the XR Battery Modules Anchor the UPS and additional XR Battery or UPS Enclosure(s) (optional) Page Page Run the Cables Connect Power in Installations with Busbars N Install isolators Install busbars Page Page Page Connect Power in Installations with Cables Install power cables Page Connect Communication Cables Connect the EPO Connect the EPO to the UPS and the XR Battery Enclosure See EPO requirements on page23. Final Mechanical Assembly Level the Enclosures (L-shaped Floor Anchoring Brackets) and Install Batteries Level the enclosures Install battery-securing and floor-anchoring brackets Reinstall the Enclosure Plates Reinstall the cable landing cover plates and the bottom plates Reinstall the top cover, battery compartment cover, and the front panel Specifications Battery voltage and current Torque specification: Isolators: M5 7 Nm (45 lbf-in). Recommended cable sizes EPO requirements Torque specification Post-Installation Checklist Page Page Page 11/20 09990-1740D-001 *990-1740D-001* APC Worldwide Customer Support