BIOS Messages

 

Action/FRU

 

 

 

 

 

 

 

 

 

Floppy Drive(s) Write Protected

1.

Ensure that the diskette drive is not set to [Write

 

 

 

Hard Disk Drive(s) Write Protected

 

Protected] in the Security Options in BIOS

 

 

 

 

 

Setup.

 

 

 

 

2.

Load default settings in Setup.

 

 

 

 

 

 

 

 

 

IDE Drive 0 Error

1.

Enter BIOS Setup and load the default settings.

 

 

 

IDE Drive 1 Error

2.

Check IDE drive jumper.

 

 

 

IDE Drive 2 Error

3.

IDE hard disk drive power.

 

 

 

4.

IDE hard disk drive cable/connection.

 

 

 

IDE Drive 3 Error

 

 

 

5.

IDE hard disk drive.

 

 

 

 

 

 

 

 

 

 

 

 

 

IRQ Setting Error

1.

Load default settings in Setup.

 

 

 

Expansion ROM Allocation Fail

2.

Enter BIOS Setup and set the Reset

 

 

 

I/O Resource Conflict(s)

 

Resource Assignments of the PnP/PCI

 

 

 

Memory Resource Conflict(s)

3.

Options to Yes, then reboot the system.

 

 

 

 

Remove all adapter cards that are NOT factory-

 

 

 

 

 

installed, then reboot the system

 

 

 

 

 

 

 

 

 

PCI Device Error

1.

Load default settings in Setup.

 

 

 

 

2.

Enter BIOS Setup and set the Reset

 

 

 

 

 

Resource Assignments of the PnP/PCI

 

 

 

 

 

Options to Yes, then reboot the system.

 

 

 

 

3.

Remove all adapter cards that are NOT factory-

 

 

 

 

 

installed, then reboot the system.

 

 

 

 

 

 

 

 

 

PS/2 Pointing Device Interface Error

1.

Re-connect PS/2 keyboard and mouse.

 

 

 

PS/2 Pointing Device Error

2.

Enter BIOS Setup and load the default settings.

 

 

 

 

3.

PS/2 mouse

 

 

 

 

4.

PS/2 keyboard

 

 

 

 

5.

System board

 

 

 

 

 

 

 

 

DMI Table Was Destroyed

1. Flash BIOS

 

 

 

 

 

 

 

 

 

Press “DEL” key to enter Setup or F1 key to

1.

Press DEL to enter Setup and reconfigure the

 

 

 

continue

 

system.

 

 

 

 

 

 

 

 

Press ESC to turn off NMI, or any key to reboot

1. Press ESC to reject NMI error or press any other

 

 

 

 

 

key to reboot the system.

 

 

 

 

 

 

 

 

 

Insert system diskette and press ENTER key to

1.

Insert a bootable disk into the floppy disk drive

 

 

 

reboot

 

or remove this disk if a hard disk is installed.

 

 

 

 

 

 

 

70

Chapter 4

Page 77
Image 77
Aspire Digital T130 manual Resource Assignments of the PnP/PCI