Aspire Digital T130 manual Post Error Messages List, Bios Messages Action/FRU

POST Error Messages List

If you cannot run the diagnostics program tests but did receive a POST error message, use “POST Error Messages List” to diagnose system problems. If you did not receive any error message, look for a description of your error symptoms in “Error Sympton List”.

NOTE: When you have deemed it necessary to replace an FRU, and have done so, you must run a total system check to ensure that no other activity has been affected by the change. This system check can be done through the diagnostics program.

NOTE: Check all power supply voltages, switch, and jumper settings before you replace the main board. Also check the power supply voltages if you have a “system no-power” condition.

NOTE: To diagnose a problem, first find the BIOS error messages in the left column. If directed to a check procedure, replace the FRU indicated in the check procedure. If no check procedure is indicated, the first Action/FRU listed in right column is the most likely cause.

BIOS Messages		Action/FRU
I/O Parity Error	1.	System board
CPU Clock Mismatch	1.	Enter BIOS Setup and load the default settings.
	2.	Ensure BIOS setting for processor is set
		correctly.
Real Time Clock Error	1.	Enter BIOS Setup and load the default settings.
CMOS Battery Bad	2. RTC Battery.
CMOS Checksum Error	3.	System Board.
Equipment Configuration Error	1.	Ensure the system configuration set in BIOS
		Setup is correct.
	2.	Enter BIOS Setup and load the default settings.
	3.	RTC battery.
	4.	System board.
System Management Memory Bad	1. Insert the memory modules in the DIMM sockets
Memory Error at MMMM:SSSS:OOOOh	2.	properly, then reboot the system.
		Memory module.
	3.	System board.
RAM Parity Error	1.	Enter BIOS Setup to disable parity check.
	2.	Memory module
	3.	System board
PS/2 Keyboard Error or Keyboard Not	1. Re-connect PS/2 keyboard and mouse.
Connected	2.	Enter BIOS Setup and load the default settings.
PS/2 Keyboard Interface Error	3.	PS/2 keyboard
PS/2 Keyboard Locked	4.	PS/2 mouse
	5.	System board
Onboard xxx... Conflict(s)	1.	Enter BIOS Setup and load the default settings.
	2.	Remove all adapter cards that are NOT factory-
		installed, then reboot the system.
Floppy Disk Controller Error	1.	Diskette drive cable/connection.
Floppy Drive A Error	2.	Diskette drive.
Floppy Drive B Error	3.	System board
On Board Parallel Port Conflict(s)	1.	Enter BIOS Setup and load the default settings.
On Board Serial Port 1 Conflict(s)	2.	Remove all adapter cards that are NOT factory-
On Board Serial Port 2 Conflict(s)		installed, then reboot the system.

Chapter 4 69