Lanier 5627, 5622 manual When the Error Message Is Displayed on the Control Panel

Troubleshooting

When the Error Message Is Displayed on the Control Panel

Note

❒If an error message that is not contained in this section appears, turn off the main power switch of the machine, and then turn it on again. If the message is still shown, note the content of the message and the error number (if listed in the table), and contact your service representative. For information about how to turn off the main power switch, see p.73 “Powering Off the Machine”.

Message	Possible Cause and Action
Cannot communicate with server.	No response from the delivery server. Possible
Check the server status. The scanned data will	causes are as follows:
be stand by.	• The delivery server is not running or has
	not started delivery service.
	• "Delivery Server IP Address" is not set cor-
	rectly in System Settings.
	• The delivery server does not recognize the
	connected device. Program a connected
	device in "Set I/O Device" of ScanRouter
	V2 Administration Utility. ⇒ScanRouter
	V2 Administration Utility Help
	• The machine may not be correctly connect-
	ed to the network. Check the LED indica-
	tors of the Ethernet board. ⇒System
		7
	Settings manual
Cannot detect original size.	• Place the original correctly.
Select scan size and reset originals.	• Specify the scan size.
	• When placing an original directly on the
	exposure glass, the opening/closing action
	of the ADF triggers the automatic original
	size detection process. Raise the ADF by
	more than 30 degrees.
Cannot select over 30 files at the same time.	To select more than 30 stored files, divide the
	operation into several times.
Cannot use destination list because the stored	More than 200 destinations were pro-
destinations have been found over 200.	grammed. Keep the number at 200 or less.
Destination and sender list update has been	Check whether the delivery server has started
failed.	operation.
Try again.
Exceeded max. data capacity.	Specify the scan size and resolution again.
Check the scanning resolution.	Note that it may not be possible to scan very
	large originals. ⇒ p.65 “The Relationship be-
	tween the Resolution and the Data Size”
Exceeded max. file capacity.	The maximum number of files that can be
Delete the unnecessary stored files.	stored is 3000. Delete unneeded files.

67