Lanier 5627, 5622 manual Standard 0deg. Right 90deg. Standard 0deg

3. Setting Originals

This chapter explains the procedure for placing the original on the exposure glass and in the automatic document feeder (ADF), and setting original scan area and orientation according to the placement method.

To correctly display the top/bottom orientation of the scanned original on a computer, the correct placement must be chosen by setup on the control panel and scanner driver.

There are two orientations for placing the original. See the table below.

Note

❒ Normally, the original size is ( ) or ( ), but in the table below, a square orig- inal is used to make the original orientation easy to understand. If the actual original size changes, a combination of original orientation and the orienta- tion specified on the control panel or scanner driver does not change.

Scanned original

	Place the original on the ex-		Place the original in the auto-
Select the placement method.	posure glass.		matic document feeder
			(ADF).
	Place the	Place the	Place the top	Place the
Place the original.	original so	original so	edge of the	original so
	that the top	that top edge	original first.	that the top
(There are two original orienta-	edge touches	touches the		edge is set
tions.)	the top left of	rear of the ex-		into the ADF.
	the exposure	posure glass.
	glass.

	When scanned by the
Speci-	delivery scanner or
	Document Server
fy the	(Specified on the con-
orien-
	trol panel)
tation.

When scanned by the

TWAIN scanner

[Standard 0deg.] [Right 90deg.] [Standard 0deg.] [Left 90deg.]

(Specified by the Scan- ner Control dialog box)

Original displayed on a compu- ter

33