At the bottom section of the screen are the navigation keys. These keys allow you to move through and select menu options.

[F6] Back [F7] Finish [TAB] Navigate [↑↓] Select [ENTER] Popup

The navigation keys vary depending on the menu level or option.

Creating a RAID 0 set (Stripe)

To create a RAID 0 set:

1.From the Define a New Array menu, select RAID Mode, then press <Enter>. A pop-up menu appears.

2.Use the up or down arrow keys to select Striping, then press <Enter>.

Mirroring

Striping

Stripe Mirroring

Spanning

3.Press <TAB> to move to the Striping Block option, then press <Enter>.

4.Use the up or down arrow keys to select the stripe block size appropriate to your drive usage, then press <Enter>.

8K ↑

16K

32K

64K

128K

Optim ↓

The available stripe size values range from 8KB to 128KB. The default stripe size is 128 KB. You must choose the stripe size value based on the projected drive usage. For low disk usage, select 8 KB/16 KB. For typical disk usage, select 64 KB. Select 128KB for performance disk usage.

TIP . For server systems, use of a lower array block size is recommended. For multimedia computer systems used mainly for audio and video editing, a higher array block size is recommended for optimum performance.

ASUS TW510-E2

6 - 5