2.10.7 Power suppy unit

Refer to this section when removing or installing power supply modules to the barebone system.

You MUST disconnect all power cable plugs from the motherboard and other installed devices before removing the power supply unit.

The picture below shows the motherboard and device connectors where the power plugs are connected. Refer to the Appendix at the end of this document for the power supply specifications.

4

2

3

1

1.24-pin ATX (motherboard power connector; hidden behind the drive cage)

2.8-pin +12V (motherboard power connector; hidden behind the drive cage)

3.2 x 4-pin plugs (SATA backplane)

4.4-pin plug (floppy disk drive; hidden)

Make sure to unplug AL L power cables from the system devices before removing the power supply module.

2 - 42

Chapter 2: Hardware setup