Asus TW510-E2 6.5.2ASUS POST Reporter™, Vocal POST messages

6.5.2ASUS POST Reporter™

This motherboard includes the Winbond speech controller to support a special feature called the ASUS POST Reporter™. This feature lets you hear vocal messages during POST that alerts you of system events and boot status. In case of a boot failure, you will hear the specific cause of the problem.

These POST messages are customizable using the Winbond Voice Editor software that came with your package. You can record your own messages to replace the default messages.

Vocal POST messages

Following is a list of the default POST messages and the corresponding actions you can take:

POS T Message	A c t i o n
No CPU installed	• Install a supported processor to the
	CPU socket. See section “2.3 Central
	Processing Unit (CPU)” for details.
System failed CPU test	• Check the CPU if properly installed.
	• Call ASUS technical support for
	assistance. See the ASUS contact
	information on the inside front cover
	of this user guide.
System failed memory test	• Install supported DDR DIMMs into the
	memory sockets.
	• Check if the DIMMs on the DIMM
	sockets are properly installed.
	• Make sure that your DIMMs are not
	defective.
	• Refer to section “2.4 System memory”
	for instructions on installing a DIMM.
System failed VGA test	• Install a PCI graphics card into one of
	the PCI slots, or a PCI Express VGA
	card into the PCI Express x16 slot.
	• Make sure that your graphics card is
	not defective.
System failed due to CPU	• Check your CPU overclocking settings
	in the BIOS setup and restore the
	default CPU parameters.
No keyboard detected	• Check if your keyboard is properly
	connected to the purple PS/2
	connector on the rear panel.
	• See section “2.7.1 Rear panel
	connectors” for the location of the
	connector.
No IDE hard disk detected	• Make sure you have connected an IDE
	hard disk drive to one of the IDE
	connectors on the motherboard.

ASUS TW510-E2 6 - 25