3.Attach Rail 2 to the other side of the drive as shown. The rail end should be on the side of the drive connectors.

Rai l handle Hol e 1

Hol e 3

Drive connectors

4.Check the HDD jumper setting. Refer to the label pasted on the HDD for the description of jumper settings. The setting “Cable Select” is recommended.

5.Carefully insert the drive into a bay on the front panel.

6.Push the drive all the way to the depth of the bay until the rail locks clicks, indicating that the drive is securely in place.

7.Connect the 15-pin SATA power plug to the power connector at the back of the drive, then connect the other end to a

4-pin plug (female) from the power supply unit.

2 - 20

Chapter 2: Hardware setup