4 . Serial ATA RAID connectors (7-pin SATA_RAID1, SATA_RAID2, SATA_RAID3, SATA_RAID4)

Supported by the Silicon Image® Sil3114 RAID controller, these connectors are for Serial ATA signal cables. These connectors support up to four Serial ATA hard disk drives that can be configured as a disk array through the onboard Silicon Image Sil3114 SATA RAID controller.

GND RSATA RXP1 RSATA RXN1 GND RSATA TXN1 RSATA TXP1 GND

GND RSATA RXP2 RSATA RXN2 GND RSATA TXN2 RSATA TXP2 GND

GND RSATA RXP3 RSATA RXN3 GND RSATA TXN3 RSATA TXP3 GND

GND RSATA RXP4 RSATA RXN4 GND RSATA TXN4 RSATA TXP4 GND

K8N-DL

SATA_RAID1 SATA_RAID2 SATA_RAID3 SATA_RAID4

K8N-DL SATA RAID connectors

•Before creating a RAID configuration, make sure that you have connected the Serial ATA cables to these connectors and have installed the Serial ATA hard disks drives; otherwise, you cannot enter the Silicon Image RAID utility and Serial ATA BIOS setup during POST.

•The RAID 5 driver is not Windows Hardware Quality Labs (WHQL) certified.

ASUS TW510-E2

4 - 9