Avaya G350 Required equipment

Before you start

Required equipment

Installation of the G350 Media Gateway 17

December 2003

Required equipment

You need the following equipment to assist you in the installation:

•One loop start analog trunk for connecting a modem.

•A separate telephone line for speaking to the service technician.

You may also need some of the following equipment for mounting the G350:

•A Phillips screwdriver if rack mounting or wall mounting the G350.

•If you will mount the G350 to a flat wall: screws to fasten the G350 to the wall.

•If you will mount the G350 to a non-flat wall:

•A 415 x 465 mm plywood board, 20 mm (0.79 in) thick.

•Wood screws to fasten the G350 to plywood.

•Screws to fasten the plywood board to the wall.

If you are installing an S8300 media server in the G350, you also need:

•One USB modem. The recommended USB modem is Multitech MultiModemUSB MT5634ZBA-

USB-V92.

•One USB CD-ROM drive.

•A laptop computer with internet browser.

If you are not installing an S8300 media server in the G350, you also need:

•A PC on the local network with a CD-ROM drive.

•A laptop computer running Windows XP or Windows 2000 and with a serial port recognized by

the operating system on the laptop. If the port is recognized, it is listed by the Device Manager.

•A modem to connect to the G350 to enable dial-in configuration. The recommended modem is the

Multitech MultiModemZBA MT5634ZBA-V-V92.

Contents

Main Page Page Page Contents About this book 9 1 Before you start 13 2 Installing the Avaya G350 Media Gateway 19 3 Preparing for configuration 33 4 Connecting devices 43 Page Page About this book Overview Audience Downloading this book and updates from the Web Downloading this book Safety labels and security alert labels Related resources Technical assistance Within the US International Trademarks Sending us comments 1 Installation workflows Full installation Staging Installation of a staged G350 Gathering information Unpacking 1 2 3 4 5 Site requirements Environmental Verification Power Verification Grounding Verification Required equipment Page 2 Gateway Step 1: Mount the G350 chassis Mounting the G350 in a rack Page Page Mounting the G350 on a wall Placing the G350 on a table Step 2: Install the media modules Combination limitations Allocating slots Page Inserting the S8300 Media Server module 1 2 3 4 5 Inserting media modules 1 2 3 4 5 Step 3: Attach ground conductors General grounding requirements Approved grounds Page Step 4: Connect power to the G350 Page 3 Step 1: Prepare configuration equipment Preparing a G350 without an S8300 for Page Preparing a G350 with an S8300 for Page Page Page Step 2: Assist the configuration Assisting a remote configuration Assisting an on-site configuration Assisting a combined remote and on-site Page Page 4 Step 1: Connect the network Step 2: Connect IP telephones Step 3: Connect non-IP telephones and trunks Connecting an analog telephone 1 2 Connecting a DCP telephone 1 2 Connecting an analog trunk 1 Connecting an E1/T1 trunk 1 Connecting an ISDN BRI trunk 1 Step 4: Install circuit protection Step 5: Connect to the Wide Area Network (WAN) Connecting the G350 to the WAN 1 2 Step 6: Install the Coupled Bonding Conductor Step 7: Install the Avaya Partner Contact Closure Adjunct 1 2 3 5 Step 1: Test the installation Testing telephones Testing trunks LSP failover testing Step 2: Remove the installation equipment A G350 Media Gateway specifications Power Cord Specifications Page Index A B C D H I L M N T U W