Avaya G350 Step 2: Remove the installation equipment

After installation

Step 2: Remove the installation equipment

54 Installation of the G350 Media Gateway

December 2003

LSP failover testing

If you have an S8300 media server module installed in the G350 and configured as an LSP, you need to

perform a test to make sure that the LSP takes over control of the G350 if the G350 becomes

disconnected from the remote media server. Work with the supporting technici an to perform this tes t. The

test involves disconnecting from the remote media server and testing the telephones connected to the

G350.

Step 2: Remove the installation equipment

Remove all equipment that you used to assist you in the installation process. This may include:

•The CD-ROM drive.

•The software upgrade CDs.

•The laptop computer.

•The modem (for installations without an S8300 module only).

NOTE:

If you have an S8300 media server module installed in the G350, leave the modem

connected to enable reporting of alarms to remote locations.

The installation is now complete.

Contents

Main Page Page Page Contents About this book 9 1 Before you start 13 2 Installing the Avaya G350 Media Gateway 19 3 Preparing for configuration 33 4 Connecting devices 43 Page Page About this book Overview Audience Downloading this book and updates from the Web Downloading this book Safety labels and security alert labels Related resources Technical assistance Within the US International Trademarks Sending us comments 1 Installation workflows Full installation Staging Installation of a staged G350 Gathering information Unpacking 1 2 3 4 5 Site requirements Environmental Verification Power Verification Grounding Verification Required equipment Page 2 Gateway Step 1: Mount the G350 chassis Mounting the G350 in a rack Page Page Mounting the G350 on a wall Placing the G350 on a table Step 2: Install the media modules Combination limitations Allocating slots Page Inserting the S8300 Media Server module 1 2 3 4 5 Inserting media modules 1 2 3 4 5 Step 3: Attach ground conductors General grounding requirements Approved grounds Page Step 4: Connect power to the G350 Page 3 Step 1: Prepare configuration equipment Preparing a G350 without an S8300 for Page Preparing a G350 with an S8300 for Page Page Page Step 2: Assist the configuration Assisting a remote configuration Assisting an on-site configuration Assisting a combined remote and on-site Page Page 4 Step 1: Connect the network Step 2: Connect IP telephones Step 3: Connect non-IP telephones and trunks Connecting an analog telephone 1 2 Connecting a DCP telephone 1 2 Connecting an analog trunk 1 Connecting an E1/T1 trunk 1 Connecting an ISDN BRI trunk 1 Step 4: Install circuit protection Step 5: Connect to the Wide Area Network (WAN) Connecting the G350 to the WAN 1 2 Step 6: Install the Coupled Bonding Conductor Step 7: Install the Avaya Partner Contact Closure Adjunct 1 2 3 5 Step 1: Test the installation Testing telephones Testing trunks LSP failover testing Step 2: Remove the installation equipment A G350 Media Gateway specifications Power Cord Specifications Page Index A B C D H I L M N T U W