Installing the Avaya G350 Media Gateway
Step 1: Mount the G350 chassis
Figure 3: Attaching a mounting bracket with cable guides
To attach each mounting bracket to the G350:
1Position a bracket over the desired mounting position.
2Affix the bracket to the chassis with three of the nine
3Tighten with the screwdriver.
The G350 is held in place by mounting screws through the two mounting ears. To avoid balancing problems and cabling complications, the racks should be filled from the bottom; that is, mount units in the lower positions first.
Before mounting the G350, check for the following:
•Ensure that the rack is bolted to the floor and is
•If the G350 is being mounted in a rack with other equipment already installed, the G350 must be positioned to avoid imbalance.
•The G350 is shipped with 3 sets of four mounting screws. Choose the set of screws that match the screw holes in the rack being used.
•The G350 weighs 22.5 pounds (10 kg) empty and between 33 and 35 pounds (between 15 and
16 kg) when equipped with media modules. Two people may be needed to mount the G350 Media Gateway in the rack.
To mount the G350 in the rack:
1Position the G350 in the rack. Ensure that there is adequate ventilation.
2Verify that the screw holes are aligned with the rack hole positions.
3Insert two mounting screws on each side.
4Tighten the mounting screws. Avoid overtightening.
5Verify that ventilation vents are not obstructed.
Installation of the G350 Media Gateway | 21 |
December 2003 |
|
