set ipv4_method=dhcp
#set ipv4_method=static #ipv4_address=192.168.160.10 #ipv4_
mask=255.255.255.0
#set ipv4_method=ipv4_address_unconfigured
#set ipv6_method=stateless
#set ipv6_method=dhcpv6
#set ipv6_method=static #ipv6_address= #ipv6_prefix_length=
set ipv6_method=ipv6_address_unconfigured
set mode=auto
submit
echo on
commit
--:- eth0 cli->
NOTE: Checkthe configuration of the progr am usedt o open a sessionagainst the appliance (SSH/Telnet,
TeraTerm / Hyper tTerminal for console,and so on) to avoidtheinclusion of a line feed characterin lines that exceed
terminalwidth, because this will affect the past oper ation.
cycle, on, off, lock and unlock
Control power on out lets on a PDU that is either connec ted to a serial port or to the
AUX/Modem port when the port i sen abled and configured wit h the Power Profile.
NOTE: Lockand unlockcommand sar e onlysupported o n Cycladesand Avocent PDUs.
To powercontrol (on, off, cycle) all outlets ofP DUs or outletsmerged to a target
(serialport configured as CAS profile with merged outlets):
1. Go to the access lev el.
--:- / cli-> cd/access
2. Launch the power command wit h the argument being the target name or PDU ID.
--:- access cli-> [cycle|on|off][<PDU_ID>]|<target name>]
To powercontrol (on, off, cycle) outletsof one specific PDU:
1. Go to the PDU level under acce ss.
--:- / cli-> cd access/<PDU_ID>
2. Launch the po wer command with a specific out let (number or name), range of ou tlets (use a
hyphen to sp ecify the range) or list of outl ets (number or name separated b y a comma).
--:- <PDU_ID> cli-> [cycle|on|off][<outlet name>|<outlet number>]
-or-
--:- <PDU_ID> cli-> [cycle|on|off]<outlet number>-<outlet number]
-or-
Chapter 2: CLI Command Set 15